Eachine Blade 185

Blade 185 is a UAV developed by the Chinese company Eachine.

Eachine Blade 185

Versions

Version 1 

Getting Started

ARF

1. Connect either a PPM or SBUS receiver using the supplied 3 wire cable (white, red, and black). Black is ground, red is +, and white is signal.
2. For PPM, Dipswitch A, Switch 1 OFF and Switch 2 ON
3. Update firmware

Update firmware

Cleanflight

1. Download and open Cleanflight
2. Connect USB cable to Blade 185
3. Select Firmware flasher in Cleanflight
4. Select NAZE
5. Full chip erase
6. Load Firmware Online
7. Flash
8. After reboot, go to configuration turn on PPM or SBUS depending on the receiver connected (The quad will beep indicating the quad is not receiving a signal from the receiver.)

Setting Failsafe

Set failsafe in Flight Controller

Openpilot GCS failsafe setup https://www.youtube.com/watch?v=wHyeY3TSTuo

Cleanflight failsafe setup https://www.youtube.com/watch?v=dikr9oDzQqc

Set failsafe on receivers with failsafe built in

See also Lemon Rx set #Failsafe

See also on OrangeRX R616XN Review https://www.youtube.com/watch?v=UUzjYCzqsxQ

Video Transmitter

Important! - Always make sure your VTx antenna is attached before powering up your Eachine Falcon 180. Running it without the antenna can result in VTx failure.

Parts & Accessories

Suggested list of parts and accessories

Accessories

B6AC Charger BANGGOOD or Turnigy Reaktor Charger HOBBYKING

Prop Balancer BANGGOOD

FPV Goggles or Display

Action Camera

Batteries to power up VRx

OpenPilot

PIDS

PIDS are highly dependent on flight setup, which includes props, battery size, externally mounted camera, etc. and also when new firmware versions are released. With each component change, the values in gyro filters and/or other features will be needed to tune again. The user postings of PIDS is to provide an approximate value covering a specific flight setup, so that pilots can tune further from there.

BetaFlight

PIDS

PIDS are highly dependent on flight setup, which includes props, battery size, externally mounted camera, etc. and also when new firmware versions are released. With each component change, the values in gyro filters and/or other features will be needed to tune again. The user postings of PIDS is to provide an approximate value covering a specific flight setup, so that pilots can tune further from there.

Troubleshooting

Flash recovery | DFU mode

To recover from a bad flash or to recover from accidentally disabling MSP Data on UART1

Cleanflight

1. Go to Firmware flasher
2. Turn on No reboot sequence, Flash on connect, and Full chip erase
3. Select Naze firmware

Quad

1. Short BOOT0 to 3.3V (3.3V is the V between G V K D). On standalone NAZE32 boards, there are BOOT pads/pins/buttons, but this allinone board does not have these pads. We have to get to BOOT0 off of the STM32 chip. See attached photo, 5th pin from the right.
2. Connect Battery (this will put the board into DFU mode. No green red LEDs/nor any beeps will be seen/heard. Only a solid blue LED will turn on)
3. Connect USB
4. Disconnect battery
5. Reconnect battery
6. Firmware will flash and a message Programming successful will display on Cleanflight

• 

  BOOT0 pin

• 

  3.3V